Visit our Twitter feed for more great content
MGExp

T-Series & Prewar Forum

TF rear axle change to 4.3 , any UK recommendations ?

Moss Motors
AutoShrine Sponsor
AutoShrine Sponsor
AutoShrine Sponsor
AutoShrine Sponsor

automobile Glenn W
Newcastle, UK   GBR
Lots of useful information on this website , a great resource !

Have a NOS ( new old stock Mowog MGA 1500 ) 4.3 : 1 crown wheel / pinion setup.

Also have the various parts for conversion ;

correct pinion flange & couple nuts
pinion oil seal
pinion head thrust washers

new pinion bearings
pinion bearing spacer
shim for above
new crownwheel bearings
gasket for axle halves

Original axle has been carefully dismantled & cleaned.

Was considering doing conversion ,& have read a lot about it ,have Cedarstrands book etc , but have lots of other work which I have to do.

Hence , think would prefer to pay someone else who is well experienced in doing this conversion properly.

Any recommendations of a competent person who could do this in UK ?

What would be a reasonable cost to set up the 4.3 cwp correctly ?

Thanks in advance for any recommendations / advice.

. Hide banner ads & support this website by becoming a > Gold Supporting Member <
Tpss Tim Parrott
Stroud, gloucestershire, UK   GBR
1938 MG TA
Try Roger Furneaux at "Mad Metrics" 01566 784111. Make sure you get a timescale. He is located in Broadwood Widger on Devon Cornwall border just off A30.

. Hide banner ads & support this website by becoming a > Gold Supporting Member <

To add your reply, or post your own questions




Registration is FREE and takes less than a minute!


Having trouble posting or changing forum settings?
Read the Forum Help (FAQ) or contact the webmaster