The all-new Front Page News Feed is now live   Read the announcement
MGExp

Buy, Sell & Trade Forum

For Sale, MGA & MGB engine parts, 15" x 5.5" wire wheels w/tires

Moss Motors
AutoShrine Sponsor
AutoShrine Sponsor
AutoShrine Sponsor
AutoShrine Sponsor

Price: ?
Location: North Carolina, USA
ghnl Avatar
ghnl Silver Member Eric Russell
Mebane, NC, USA   USA
1961 MG MGA "Calvin"
Time for some garage cleaning & replenishment of racing funds! Suggested donations listed - or make an offer (be generous, I blew 2 engines this year...). 5% of selling price will be donated to the forum.

1) sold Oil pan for 3-main bearing engine. 19 bolt holes, fits MGA or early MGB engines. Cleaned, stripped and painted with Rustoleum etching primer and Rustoleum 'Merlot' $45 plus shipping (the photo makes it look redder than it is, the paint is more burgandy in real life)

2) MGA carb heat shield. As-is (no extra charge for patina...) $10 plus shipping. Note - two insulation rivets are missing. OR, I can strip, prime & paint (insulation material will be removed and reinstalled with non-original rivets) - $35 plus shipping.

3) MGA carb to distributor vacuum pipe. Olives & nuts are present on both ends of the vacuum pipe. See reply #5 below for new info/price.

4) MGA intake Manifold. As-is (with patina) $20 plus shipping. I can clean the intake manifold in my sandblast cabinet - for $10 additional (so $30) plus shipping.

5) sold MGA exhaust manifold. One stud thread repaired with a helicoil, the other two are in good condition. $45 as-is plus shipping OR I will sandblast & paint with high-temp paint for an additional $50 (so $95) OR I can take it to Jet-Hot for coating of your choice. Jet-Hot is local to me, I can drop it off & pick it up then ship it to you - you pay the cost of the Jet-Hot coating plus $45 & shipping.

6) sold MGB exhaust manifold. Has 9/16" thick flange. $45 as-is plus shipping OR same sandblast or Jet-Hot deal as above.

7) MGB intake manifold. Has 9/16" thick flange. (I do not have any MGB carbs) As-is (patina...) $10 or cleaned in my sandblast cabinet - for $10 additional (so $20) plus shipping.

8) six 15" X 5.5" wire wheels with 185-70 X 15 Vredestein Sprint Classis tires. Bought new from Hendrix Wire Wheel in 2014. I used these for my vintage raced MGA for 3 years (2014 -2016), approximately 10-12 events. I have since switched to bolt-on aluminum wheels and these are surplus to my needs. $300 each (wheels with tires). I am not sure how much shipping would cost - if you buy them all I could negotiate an Eastern USA delivery cost based on distance (fuel costs). If you buy the wheels/tires and also want any other items then I'd bring those items for no extra shipping cost.

9) MGA or early MGB oil filter cannisters (I have 2 but forgot to take photos). Includes head assembly & patina. (see https://mossmotors.com/mgb/engine-performance/oil-system/hanging-canister-oil-filter) $20 each plus shipping.

10) sold MGA external oil pipe. (no photo...) I assume it also fits the early MGB (same Moss part number).

For more info or bigger/better photos send PM with your email address.



Eric Russell ~ Mebane, NC
1961 MGA #61, 1981 Alfa Romeo GTV6, 1984 Alfa Romeo Spider, 1991 Honda ST1100



Edited 10 time(s). Last edit at 2019-01-15 06:53 PM by ghnl.

. Hide this ad & support a small business by becoming a Gold Supporting Member

Attachments:
MGA parts.jpg    72.6 KB
MGA parts.jpg

MGB parts.jpg    59.9 KB
Sign In or Register to view this photo
Wire Wheels.jpg    39.7 KB
Sign In or Register to view this photo
Was this post helpful or interesting?
Yes No Thank
ghnl Avatar
ghnl Silver Member Eric Russell
Mebane, NC, USA   USA
1961 MG MGA "Calvin"
I've had a few nibbles on the wheels/tires but no sales yet.

I need a new engine for 2018 so buy early, buy often...



Eric Russell ~ Mebane, NC
1961 MGA #61, 1981 Alfa Romeo GTV6, 1984 Alfa Romeo Spider, 1991 Honda ST1100


Attachments:
rod 01.JPG    28.3 KB
rod 01.JPG

Was this post helpful or interesting?
Yes No Thank
ABOMGB Albert Oberst
Lexington, KY, USA   USA
I'll buy the MGB exhaust manifold sandblasted.

. Hide this ad & support a small business by becoming a Gold Supporting Member
Was this post helpful or interesting?
Yes No Thank
zebramg Avatar
zebramg Silver Member bill wingard
Pell City, AL, USA   USA
1964 MG MGB
I'll take the vacuum pipe if you still have it. Bill

Was this post helpful or interesting?
Yes No Thank
ghnl Avatar
ghnl Silver Member Eric Russell
Mebane, NC, USA   USA
1961 MG MGA "Calvin"
MGB exhaust manifold has been sold, everything else is still available.

The MGA vacuum pipe has a small defect - it appears something rubbed partway through the pipe. It could be repaired by cutting out the damaged section (~ 1/4"winking smiley and using a short length of rubber hose to reconnect the ends -or- by soldering a 'patch' over the defect. $5.00 - plus shipping 'as-is' or $10.00 - plus shipping with a soldered patch.



Eric Russell ~ Mebane, NC
1961 MGA #61, 1981 Alfa Romeo GTV6, 1984 Alfa Romeo Spider, 1991 Honda ST1100

Was this post helpful or interesting?
Yes No Thank
ghnl Avatar
ghnl Silver Member Eric Russell
Mebane, NC, USA   USA
1961 MG MGA "Calvin"
Everything except the MGB exhaust manifold is still available. Probably can't ship in time for a Christmas gift though...

And, if you'd like the wire wheels without the tires, I can have the tires dismounted. Wheels only - $175 each or BRO (plus shipping).



Eric Russell ~ Mebane, NC
1961 MGA #61, 1981 Alfa Romeo GTV6, 1984 Alfa Romeo Spider, 1991 Honda ST1100

Was this post helpful or interesting?
Yes No Thank
ghnl Avatar
ghnl Silver Member Eric Russell
Mebane, NC, USA   USA
1961 MG MGA "Calvin"
Still looking for buyers...

Also, I bought the parts shown here: https://www.mgexp.com/phorum/read.php?42,3706194 - if you have any needs let me know. (I'm planning to keep the steering rack and transmission but everything else is available.



Eric Russell ~ Mebane, NC
1961 MGA #61, 1981 Alfa Romeo GTV6, 1984 Alfa Romeo Spider, 1991 Honda ST1100

Was this post helpful or interesting?
Yes No Thank
ghnl Avatar
ghnl Silver Member Eric Russell
Mebane, NC, USA   USA
1961 MG MGA "Calvin"
The parts in post #1 (except those marked 'sold') are still available.

And most of the parts shown here: https://www.mgexp.com/phorum/read.php?42,3706194 are still available (I'm keeping the steering rack & the transmission is gone) [SOLD]1600 block has been sold.

[SOLD] There is a box labeled MGB wiper motors (there are two).

There is an assortment of wire wheel knock-offs (both 12 TPI & 8 TPI). Not perfect but useable. And an MGA 1500 style coil mounting bracket (attaches to generator) and a 1600 style coil mounting bracket (attaches to motor mount). There is a couple of bins of assorted nuts/bolts/screws so if you are looking for something odd & original, describe it as best you can - maybe it's in there?

Make offers - I'd mostly like for this stuff to go to someone who can use them/needs it.



Eric Russell ~ Mebane, NC
1961 MGA #61, 1981 Alfa Romeo GTV6, 1984 Alfa Romeo Spider, 1991 Honda ST1100



Edited 2 time(s). Last edit at 2019-01-04 09:28 PM by ghnl.

Was this post helpful or interesting?
Yes No Thank
ghnl Avatar
ghnl Silver Member Eric Russell
Mebane, NC, USA   USA
1961 MG MGA "Calvin"
A friend who has sold his MG's (he had A's & B's) gave me a couple of boxes of left over/spare parts. Some are new, some used. Attached are some photos - if you see anything you can use let me know. If you need more detail or better photos let me know. PM me with your wants & mailing address - they can be yours for the cost of shipping.



Eric Russell ~ Mebane, NC
1961 MGA #61, 1981 Alfa Romeo GTV6, 1984 Alfa Romeo Spider, 1991 Honda ST1100


Attachments:
20181020_114600-1.jpg    27.9 KB
20181020_114600-1.jpg

20181020_121214.jpg    38.8 KB
Sign In or Register to view this photo
20181020_122351.jpg    45 KB
Sign In or Register to view this photo
20181020_114538.jpg    43.1 KB
Sign In or Register to view this photo
20181020_120456.jpg    51.9 KB
Sign In or Register to view this photo
Was this post helpful or interesting?
Yes No Thank
joemamma Gold Member Robert White
Monroe,NC 28112, USA   USA
Sending pm on ash tray,4 rubber under car wiring holders ,GT roof light, half round under body wire holder, gas cap!
Bob



Bob
2x 63 MGB, 67 MGBGT, 77MGB ,09 Corvette, 60 MGA, 67 TR4A-irs

Was this post helpful or interesting?
Yes No Thank
ghnl Avatar
ghnl Silver Member Eric Russell
Mebane, NC, USA   USA
1961 MG MGA "Calvin"
A couple of items I forgot to photograph.

The Wiper/Washer Switch has been [SOLD]

And a Moss #458-415 "Extension, right, splash panel" https://mossmotors.com/extension-right-splash-panel-british-motor-heritage



Eric Russell ~ Mebane, NC
1961 MGA #61, 1981 Alfa Romeo GTV6, 1984 Alfa Romeo Spider, 1991 Honda ST1100



Edited 5 time(s). Last edit at 2019-01-04 09:32 PM by ghnl.


Attachments:
20181021_120428.jpg    47.9 KB
20181021_120428.jpg

20181020_194224-1.jpg    40.8 KB
Sign In or Register to view this photo
Was this post helpful or interesting?
Yes No Thank
kensil52td Kenneth Silvia
Fall River, Mass /.bristol, USA   USA
MGA 4.3 differential pumpkin ----chunk ? ken

Was this post helpful or interesting?
Yes No Thank
ghnl Avatar
ghnl Silver Member Eric Russell
Mebane, NC, USA   USA
1961 MG MGA "Calvin"
In reply to # 3829268 by kensil52td MGA 4.3 differential ?

Nope, sorry.

Steering wheel center has been spoken for.

Gas cap, rubber under car bits, moulding rivets, ash tray & interior light have been spoken for.



Eric Russell ~ Mebane, NC
1961 MGA #61, 1981 Alfa Romeo GTV6, 1984 Alfa Romeo Spider, 1991 Honda ST1100

Was this post helpful or interesting?
Yes No Thank
hsisodia Avatar
hsisodia Silver Member Hersh Sisodia
East Lansing, MI, USA   USA
1970 MG MGB MkII "Esmeralda"
2005 Mini Cooper
Eric, how much for the wiper washer switch?



Cheers!
Hersh

Was this post helpful or interesting?
Yes No Thank
ghnl Avatar
ghnl Silver Member Eric Russell
Mebane, NC, USA   USA
1961 MG MGA "Calvin"
Sorry, switch has been sold.



Eric Russell ~ Mebane, NC
1961 MGA #61, 1981 Alfa Romeo GTV6, 1984 Alfa Romeo Spider, 1991 Honda ST1100

Was this post helpful or interesting?
Yes No Thank
. Hide this ad & support a small business by becoming a Gold Supporting Member

To add your reply, or post your own questions




Registration is FREE and takes less than a minute!


Having trouble posting or changing forum settings?
Read the Forum Help (FAQ) or contact the webmaster