Member Page: Peter Cummins
Member ID: comart45Status: Free Member
Member Since: 1999-11-30
Home Site: The MG Experience
Last Login: 2013-07-24 06:18
Forum Activity: 2013-07-24 06:18
Forum Posts: 9,304
I was an Art Director and Production Manager for an Advertising agency from 1976-1990. I then started free-lancing commercial art, mainly Architectural Renderings of residential and commercial properties. That business dried up with the current Housing Crisis, so now I am a Millworks specialist at Home Depot. This is Emily now... Peter went to the angels on the 1st of November 2010. complications after surgery.
Personal Vehicle Registry
No vehicles listed in the Registry.
Member Journal – Peter Cummins
There are 2 total entries in this Journal.
Posted on: Friday October 30, 2009
It is very simple to make. I took the old valve off and using a hacksaw cut though it . See pictures. Then drill out the hole with a 7/16" drill bit. Thread the hole with a 1/4"N.P.T. tap (go to Harbor Freight for that tap. N.P.T. stands for "National Pipe Thread". It's totally different than regular nut and bolt threads. It is specific to plumbing fixtures. The outside dimension of the pipe nipples is really 1/2", but the 1/4" refers to the inside diameter of the pipe.) All fittings are 1/4"NPT...
Posted on: Saturday July 7, 2007
MG Experience Library Articles
|2010-06-17||mgb||Foolproof Manual Heater Valve||Service:Cooling and Heating||4|
|2010-06-17||mgb||Delco Alternator Mount||Service:Electrical and Instruments||2|