Apr 17, 2012 22:18:22
Hey Mark!
When you installed your new front braided brake lines how did you secure
the middle section of the hose to the shock mount?
Mark-Braided Brake Line Question
The MG Experience ~ Modern MGs Forum ~ Archives
For discussion of all modern MG car models, such as the MG RV8, MG Metro, MG Maestro, new MGF, MGTF, Z series and MG6. Also the official Forum of the Canadian Modern MG Rover Car Club.
If you would like to post a reply, please click below to visit the The MG Experience Forums:
Modern MGs Forum: Mark-Braided Brake Line Question
http://www.mgexp.com/phorum/read.php?54,2043284,page=1
Join the discussion, post your photos, or ask your own questions. Membership is FREE!
Modern MGs Forum: Mark-Braided Brake Line Question
http://www.mgexp.com/phorum/read.php?54,2043284,page=1
Join the discussion, post your photos, or ask your own questions. Membership is FREE!
Apr 18, 2012 06:12:39
No I didn't.
In order to get the tab on the brake hose to align with the slot in the caliper, the brake hose ends up back towards the inner wheel well.
I initially put the brake hose next the shock mount with zip ties but it made for some very tight turns and the tab would not align with the slot. So I went about mounting the tab to align with the slot and see where the hose wanted to go. It naturally went to the back of the wheel well, directly under where the hose connects to the brake line, and it is well away from the tire.
Would you like a pictures?
Apr 18, 2012 11:11:25
Pictures would be great. No hurry as I'm not going to install the hoses until
my replacement displacers arrive from Blighty.
Apr 18, 2012 13:08:44
Here's a couple pictures for you Rich showing how the hose is routed.
This is an archived discussion from the The MG Experience Forums
If you would like to post a reply, please click below to visit the The MG Experience Forums:Modern MGs Forum: Mark-Braided Brake Line Question
Archive Index | The MG Experience Forums | Return to The MG Experience